Standard International Group (HK) Limited

This device can be used to measure high temperature, low temperature, thermal-cold cycling, constant temperature and humidity, rapid temperature change, and alternate change between high and low temperature.
· Temperature rise and fall, humidification and dehumidification can be controlled separately. Hence, the efficiency of the device is improved to save over 20% electricity, lower the breakdown rate, prolong the service life span and decrease the test cost.
· The touch setting mode is controlled by microprocessor with 12 sets of P.I.D automatic calculation function, which controls the temperature and humidity more precisely.
· The deviation of temperature and humidity can be revised by programming.
· When breakdown occurs to the temperature probe, it can be automatically detected.
· Automatic water circulation or water supplement.

 TFT、LCD color screen
· USB interface
· Nitrogen welding in the whole process
· Load calorific value up to 800℃
· Compressor vibration and noise is eliminated through a special vibration-absorbing material.
· Double protection against over-temperature empty burning.
· Superconducting evaporator film treatment, can improve the efficiency of 10%.
· The binary refrigeration system uses plate-type heat exchange.
· Stainless steel single shaft fan motor
· Test stand stainless steel passivation treatment does not produce electrochemical corrosion
· Servo refrigerant servo valve drive.
· System-wide compressor three-year warranty.
·  Sweden original longevity ultrasonic humidifier, energy saving and environmental protection.