Others

LD series insertion electromagnetic flowmeter used to measure the conductivity of the liquid, JGLD series insertion electromagnetic flowmeter suitable for measuring large-diameter pipe, insertion electromagnetic flowmeters are widely used in petroleum, chemical, metallurgical, power, paper, food , Water treatment and other industries。



Model:
HKLD series

Caliber: DN350 - DN2000
Accuracy:
± 1.5%Measurement standards ±1.0% Special measurements ± 0.5% High-precision measurements

Minimum conductivity :
5μs/cm

Measuring range :
Recommended range: 0.5m / s ~ 10m / s continuously adjustable
Maximum use of: 0.2m / s ~ 15m / s continuously adjustable

Medium temperature : -20- +150℃
Ambient temperature : -20- +60℃
Fluid pressure : ≤ 1.6MPa
Protection :
Sensors 　　Converter
IP67 　　　IP67
IP68 　　　IP67

Material:
Probe is made of 304 stainless steel, 316 stainless steel electrode material, insulation layer PTFE.

Electrical interface :
M20×1.5,1/2〞NPT

Display :
Standard double liquid crystal display, can display instantaneous and cumulative flow。

Power source:
220VAC 50HZ 24VDC

Explosion levels：
Exd[ia]iam ll CT5

Signal output：
1、Switch can be set: pulse output (up to 1000HZ）；
High / low flow alarm；
ATC alarm；
Indicate flow direction；
Failure alarm；
2、Current output :4-20mA output。

Configuration mode：
1、Through three key on-site manual configuration。
2、Field configuration by remote control。
3、Site through the configuration of the terminal。
Memory: EEPROM memory will not disappear, no battery save。