Paper Machinery

Pellet production line process:
(a)Peeling Process
Wood debarker machine is applicable to peel the log of MDF board and pape rmaking industry,Website:http://www.fdsp-cn.com, it is mainly used to peel log, small wood and so on, the peeled rate is more than 95 percent.
(b)Chipping Process
In the pellet plant before raw materials are made into biomass pellets, they are
first reduced into much smaller, uniformly-sized particles. When the thick nedd is larger than 10mm or the size is greater than 50*50mm, a chippper is needed to chip these materials into smaller pieces. FDSP manufacturer lost cost maintenance wood shavings pellet production line
(c)Grinding Process
The hammer mill is used to further crush these small pieces into particles of less than 3mm in diameter.FDSP manufacturer lost cost maintenance wood shavings pellet production line
(d)Drying Process
After raw materials are crushed a dryer is needed since most raw wood materials have a moisture content of about 50%. However, the optimal moisture content for pelletiztion is 13%-15%. Therefore a rotary dryer is included in the pellet plant to reduce the moisture content. After crushing and drying you can begin making wood pellets.FDSP manufacturer lost cost maintenance wood shavings pellet production line
(e)Pelletizing Process
After crushing and drying the raw material properly it is then ready for the pellet mill. The pelletizing machine or press is the key piece of machinery in the pellet plant. It should be mentioned that impurities in the raw materials like metal or stone,may damage the die and rollers of pellet making machine. FDSP manufacturer lost cost maintenance wood shavings pellet production line
(f)Cooling Process
Usually after pelletizing, the temperature of pellets is between 60-80 degrees and the moisture content is close to 15%. For storage purpose, a cooler must be used to reduce their surface temperature and moisture content.FDSP manufacturer lost cost maintenance wood shavings p