Filters

2H606T step motor driverCharacteristics :The motor driver 2H606T is two phase hybrid stepper motor driver ,Website:http://www.wotomotors.com, driving nema 23 and nema 24 two phase stepper motor . It has 16 microsteps , ?MAX micro step is 64 subdivision ; Current range is 1.4A ~ 5.6A , 8 class ?output current ,current resolution is 0.6A ; with function of half current ?.over-voltage and over-current protection etc . It is DC power supply , working ?voltage is 24VDC - 50VDC , voltage shouldn’t be over 50VDC , and not below ?20VDC .Parameters ?:Input ?Power supply :24VDC ~50VDCOutput ? ?Current1.4A～5.6ADrive ?WayPWM constant ? ?current chopping ,three phase Sine wave output currentSuitable ?stepper motor57, ? ?60 series two phase stepper motorAmbient ?environment-10℃～55℃ ? 15～85%RH、No condensation. Non-corrosive, flammable, explosive, ? ?conductive gas, liquid and dustKeeping ? ?enviroment－40℃～+55℃, ＜93%RH,No condensation, no frostSize (L*W*H)??????????????????????? 118*75.5*34 mmNet Weight0.25 KgDescription :? ? ?Microstep setting?Users can set the driver Microstep by the SW5-SW8 ? ?four switches,total 16 micro-step. When you set the ? ?microstep , pls stop the driver working.The ? ?setting of the specific Microstep subdivision, please refer to the ? ?instructions of the driver panel figure .Output current settingUsers can set the driver Microstep by the SW1-SW3 three ? ?switches. The setting of the specific Microstep subdivision, please refer to ? ?the instructions of the driver panel figureAutomatic half current functionUsers can set the driver half flow function by SW4. ? ?& quot;OFF& quot; indicates the quiescent current is set to half of the dynamic ? ?current, that is to say, 0.5 seconds after the cessation of the pulse, ? ?current reduce to about half automatically. & quot;ON& quot; indicates the ? ?quiescent current and the dynamic current are the same. User can set SW6 to ? ?& quot;OFF& quot;, in order to reduce motor and driver heating and improve ? ?reliability.signal InterfacePUL+ and PUL- a