Hardware & Tools

keensert threaded insert may be used in alloys,light materials,steel and cast iron to increase the strength of the thread in these materials.they can also be used for thread repair,whereas the defect thread can be replaced with the same nominal diameter.
keensert threaded insert have less attrition.A multiple tightenting and lossening of the bolt is possible.locking inserts include a dry film lubrication on the surface to protect the screw from galling.
keensert threaded insert have a positive lock against rotation and vibration.
keensert threadeed insert have 2 and 4 pre-assembled kees depending on the diameter.after installation of the kees into the parent material the assembly is form-closed.No check with a thread gauge according to the DIN standard possible in the area of the kees.
Pull-out-strength for Keensert calculation as follows:
pull-out-strength(N)=shear engagement (mm2)x ultimate shear strength of parent material (N/mm2)
data for shear engagement see installation data.


type size inner(6H) outer(6g) length drill

min M2 M2*0.4 M4*0.7 3 3.4
M2.5 M2.5*0.45 M4.5*0.75 3.8 3.9
M3 M3*0.5 M5*0.8 4.2 4.4
M4 M4*0.7 M6*0.75 5.2 5.5

thinwall M5 M5*0.8 M8*1.25 8 6.9
M6 M6*1 M10*1.25 10 8.8
M8 M8*1.25 M12*1.25 12 10.8
M10 M10*1.5 M14*1.5 14 12.8
M12 M12*1.75 M16*1.5 16 14.8


heavy duty M4 M4*0.7 M8*1.25 8 6.9
M5 M5*0.8 M10*1.25 10 8.8
M6 M6*1 M12*1.25 12 10.8
M8 M8*1.25 M14*1.5 14 12.8
M10 M10*1.5 M16*1.5 16 14.8
M12 M12*1.75 M18*1.5 18 16.8


type size inner(2B) outer(2A) length drill

min 2-56 2-56 8-32 0.12 0.134
4-40 4-40 10-32 0.17 0.161
6-32 6-32 12-28 0.17 0.187
8-32 8-32 1/4-28 0.22 0.228


thinwall 10-32(10-24) 10-32(10-24)