Cryolipolysis Series & 360 Degree Freezing Fat Machine

8 Cryo Pads EMS Fat Freezing Equipment

Theory

Cryolipolysis

Cryolipolysis is an unique non-invasive method for the selective reduction of fat cells with controlled localized cooling. This fat freezing crystallization procedure makes fat cells under a process "apoptosis". Non-vacuum application deliver a great comfortable cooling treatment without oedemas, bruising and skinniness caused by suction of criolipolisis vacuum cup.

EMS

Electrical Muscle Stimulation(EMS), also known as neuromuscular electrical stimulation(NMES) or electromyostimulation, is a protocal that elicits a muscle contraction using electrical impulses that directly stimulate your motor neurons. The stimulation creates muscle contractions that can be quick and frequent, fat with long pauses, or contractions that are held for several seconds or minutes at a time.

According to human neurology, 600 times electronic pulse currents per minute directly act on muscle nerve, can deeply reach the fat body, stimulate the most intensive neuro to induce muscle to generate shrinkage exercise. In the rapid active state of fat cells, the local fat layer is sufficient exercise, the body's basal metabolism is improved, and the effect is still continued within 24 hours after use. The kinetic energy is transformed into slimming energy, quickly eliminates human fat, and achieves more slimming effect than traditional methods, and tightens the curve of the whole body.

Application

Eliminate the abdomen, waist, back, buttocks, thighs, butterfly sleeves, double chin excess fat, reduce the circumference of the treatment site.

There is no need to use anesthesia, there is no pain, numbness, will not cause scar, trauma, no need to recover.

Parts Introduction

Preparation

Antifreeze membrane must be used when using this machine, otherwise frostbite may occur.

For initial use, the freezing temperature range should be set between 0 ° C and -5 ° C.

Ensure the water tank is full of 3.5L water for cooling system.

The hand piece is well connected with the equipment.

Treatment Course

The Cryolipolysis and EMS function can work simultaneously or independently.

Crylipolysis: 3-4 times as a treatment course. The interval time between two treatments is 30 days. The treatment time for cryolipolysis is 40-50 minutes, and the EMS function can be activated in the last 15-20 minutes of the cryolipolysis treatment.

If the EMS function is used alone, the single treatment time is 15-20 minutes, and the maximum time is no more than 25 minutes. 3 times a week, two weeks for a course of treatment.

Parameters

Operation