Industrial Supplies Agents

Wetted Parts
Liners – Hard metal liners are completely interchangeable with pressure molded elastomer. Elastomer seal rings back all liner joints. Easily replaceable liners are bolted, not glued, to the casing for positive attachment and east of maintenance.
Impeller – Hard metal and molded elastomer impellers are completely interchangeable. Front and rear shrouds have pump out vanes that reduce recirculation and seal contamination.
Throat bush – Hard metal and molded elastomer impellers are completely interchangeable. Wear is reduced and maintenance simplified by the use of tapered mating faces to allow positive accurate alignment during assembly and simple removal.
Shaft seal
Expeller Seal(Centrifugal Seal) – Available with low flow water flush or zero flow (grease lubricated) options to provide exceptional sealing where water introduction to the seal is intolerable or limited.
Stuffing Box – Gland sealing with packing and lantern ring.
Bearing assembly?- A large diameter shaft with short overhang minimizes deflection and contributes to long bearing life. Only four through bolts are required to hold the cartridge type housing in the frame.
Pump Casing – Casing halves of cast or ductile iron with external reinforcing ribs provide high operating pressure capabilities and an extra measure of safety.
Frame Base – A very robust one-piece frame cradles the cartridge type bearing and shaft assembly. An external impeller adjustment mechanism is provided below the bearing housing for easy adjustment of impeller clearance.

H series Centrifugal Heavy Duty Slurry Pumps are designed for handling highly abrasive,high density slurries in metallurgy industry, mining industry, coal, power, building material and other industrial departments. The pumps of these model also can be installed as multi-stage series.
This series slurry pump also named according the working conditions, such as De-Watering Screen Pump, Taillings Pump, Metboom Pump, Feedprep Pump, Scavenger Feed Pump