Cast & Forged

22KW Automatic Steel Plate Granary Silo Forming Machine 120mm Shaft Diameter?

?

Silo roll forming machine:

I:Composition of machine
Roll forming main machine................1 unit
10Tons hydraulic de-coiler with coil car.......1 set
Punching system.....................2 units

Curving Machine..........................1 unit
Control panel..........................1 unit
Hydraulic station.....................1 unit
3M auto stacker............ .........2 unit
Spare tools........................one box

II: Details of each composition
A: Roll forming main machine
1: Coil width: 1000mm effective width:930+3-3 mm (design base on 3mm)
2: working speed: 0-20m/min (not contain cutting and punching)
3: roll station: 17stations

4: material of roller:Gcr15 bearing material;, polished and coated with chrome HRC58-62°
5:material of main shaft:45 forge steel(Same as SAE1045) diameter roller: 150mm
6: main power: 45kw
7: forming thickness: 2.5mm—3.5mm
8: Transmission: by gear box 200*500(outside
9: machine with security fences
10: Roll former has leveling bolts in the base
11: Cutting:
(1)Machine adopt hydraulic cutting
(2)Cutting after forming: Cut the sheet after roll forming to required length
(3)Cutting motion: The main machine automatically stops and the cutting will take place. After the cutting, the main machine will automatically start.
(4)Material of blade: CR12with heat treatment
(5)Length measuring: Automatic length measuring
(6)Tolerance of length: 4700mm+/- 2mm

B.de-coiler
l Single unrolling machine, one side can put material
l Adopt automatic hydraulic system
l Coil weight (Max):10000kg
l Inter diameter: 470mm-520mm
l Maximal out diameter:1800mm
l Oil cylinder dia:120mm working pressure: 20mpa (=20Tons)
l Coil width (Max.):1000mm
l Working speed: 0-25m/min
l Power: 5.5KW
l Hydraulic power: 3kw
l De-coiler should be with Loop control and hold down
l Coil car: 10Tons
l the motor power of coil car: 3Kw
l Pressure: 12Mpa


C: punching system
1: depend on customer punching drawing complete machine need two punching unit and
2: depend on customer punching request this machine adopt punching after roll forming.
3: punching mould material: Cr12 with HRC58-62°
4: hydraulic power: 11KW
5: pressure: 25Mpa
6: diameter of oil pump: 200mm

D: Control panel Japan Mitsubishi
(1)Voltage, Frequency, Phase: 380 V, 50 Hz, 3Phase
(2)Automatic length measurement:
(3)Automatic quantity measurement
(4)Computer used to control length & quantity. Machine will automatically cut to length and stop when required quantity is achieved
(5)Length inaccuracy can be amended easily.
(6).Control panel: Button-type switch and touch screen
(7)Unit of length: millimeter (switched on the control panel)
(8) Laguage: English, Spanish and Chinese

E: Hydraulic station
1: hydraulic station power: 11kw
2: hydraulic pressure: 25Mpa

?

?

Service:
# # Before-sales # # We will answer the customer asap. (within 24hours)
# We can design the machine according to customer’s detail requests.


# After-service: # # In correct operation & maintaining, the machine is guaranteed for one year
# If necessary, we will dispatch technicians to install and commissioning, and also our technicians will teach and training the customer’s workers to use the machine better.
# We will provide long-term technical assistance.




?